Worth Data 5000 - Manual (Page 36)

35
Code 93 / Code 11
CODE 93/CODE 11
CODE 93 --------------------------- ON/OFF 1
CODE 93 FULL ASCII ---------- ON/OFF 2
CODE 11 --------------------------- ON/OFF 3
CODE 11 CHECK TRAN ------ 0/1/2 4
DONE/EXIT -------------------------------- 0
CHANGE SETTING #: _
Code 93 is similar in character set to Code 39. See Appendix L: Code 93 for more information. Code 93 is not a commonly used bar
code symbology.
GS1-DataBar/ RSS-14 / Other Bar Codes
DATABAR/RSS-14 OPTIONS
DATABAR/RSS-14 ------------- ON/OFF 1
OTHER BAR CODE OPTIONS
STORAGE TEK LABEL ------ ON/OFF
2
LABELCODE 5 ------------------ ON/OFF 3
LABELCODE 4 ------------------ ON/OFF 4
BAR CODE ID’S ----------------- ON/OFF 5
DONE/EXIT -------------------------------- 0
CHANGE SETTING #: _
By default, GS1-DataBar (RSS-14) is disabled. Press the 1 key to toggle through the DataBar options listed above. We support the
standard and stacked version of GS1 DataBar. For more information on GS1 DataBar, see the GS1.org website at
http://www.gs1.org/barcodes/databar
Bar Code ID‟s are characters assigned to each bar code type to identify that particular type of code. These Bar Code ID‟s can be used
to identify what type of bar code you are using when you are not sure or you want your application to differentiate between the
different types. This applies only when the TriCoder is used in NON PORTABLE mode.
The Bar Code ID‟s are assigned as follows:
Bar Code ID Bar Code ID
Codabar a Code 39 b
UPC-A c EAN-13 d
I 2of5 e 2 of 5 f
Code 128 g Code 93 i
MSI j UPC-E(0) n
UPC-E (1) o EAN-8 p
GS1 Data Bar RSS-14 r StorageTek s
Plessey x LabelCode 4 y
LabelCode 5 z
The ID character is transmitted in front of the bar code data.