Walker IMPLEMENT HITCH SB6670 - Manual (Page 23)

Assembly Instructions
19
SETUP INSTRUCTIONS
Walker Implements are shipped partially assem-
bled. After uncrating the implement adaptor and/or
implement(s), initial setup is required.
NOTE: During the process of unpacking, any dam-
aged or missing parts should be noted and reported
to the delivering carrier immediately (put in writing
within 15 days). The carrier will provide directions
for proceeding with a claim to receive compensation
for damage.
IMPLEMENT HITCH
Implement Hitch Installation
1. Remove the mower deck from the tractor if nec-
essary. Refer to the appropriate Tractor Own-
er’s Manual.
2. Lightly grease each tractor support arm (2) on
the tractor. Refer to Implement Hitch Installa-
tion photo for location of tractor support arms.
3. Engage the hitch frame tube sockets on the
tractor support arms. Slide the implement hitch
onto the support arms approximately 3 in. (76
mm).
4. Install the hitch pin through the hole on the end
of each support arm to lock the hitch in place.
Two (2) hitch pins are included in the owner’s
packet of materials.
Implement Hitch Installation
IMPORTANT: If the tractor body needs to be raised,
the PTO shield must be in the closed or down po-
sition and the implement must be in the lowered
position. The only time the PTO shield needs to be
open or raised is when connecting or disconnecting
the driveline for the rotary broom, snowblower, or
debris blower.
PTO Shield in CLOSED Position
5. Loosen the 3/4-10 jam nut on the end of the im-
plement Hitch. Adjust the 3/4-10 x 2 in. hex bolt
until it contacts the cross-member of the tractor
frame. Securely tighten the 3/4-10 jam nut to
prevent the bolt from moving.
Implement Hitch Jam Nut Adjustment
IMPORTANT: This adjustment will need to be
made only once if the same tractor and hitch are
used together. If the hitch will be used on more
than one tractor, this adjustment will be required
every time the hitch is mounted on a different
tractor.
Grease Tractor
Support Arms
Hitch Frame
Tube Sockets
Hitch Pins Lock Hitch on Support Arms
PTO Shield
in CLOSED
Position
3/4 - 10
Jam Nut
3/4 - 10 x 2"
Hex Bolt