Walker IMPLEMENT HITCH SB6670 - Manual (Page 29)

Assembly Instructions
25
Prepare Rotary Broom for Installation
3. Attach the female broom driveline half (with
quick connect yoke) over the male broom driv-
eline half. Set the driveline on its support.
NOTE: Driveline sliding surfaces must be
greased.
Assemble Rotary Broom Driveline
4. Insert the male quick hitch section of the imple-
ment hitch into the female quick hitch of the ro-
tary broom and place the male quick hitch lever
fully forward to the LOCKED position. Secure
the male quick hitch latch with the linchpin. Re-
fer to Hitch Locking Lever in
Operating In-
structions.
Attach Broom to Implement Hitch
5. Connect the broom driveline to the tractor PTO
shaft by sliding back the locking collar on the
yoke, then push the yoke over the PTO shaft
until the locking collar snaps back fully. Make
sure the driveline is well secured at both ends.
Connect Broom Driveline to Tractor PTO Shaft
Stand Support
Bracket
Hairpin
Parking Stand
Drive Shaft
Yoke
Reduction
Shaft
DANGER
This shaft turns at very high RPM. If the
collar is not locked to the PTO shaft at the
tractor end, or if the yoke at the broom
end is not secured properly, the driveline
can fly loose with great force capable of
causing serious injury or death.
Hitch Locking
Lever
Male Quick
Hitch
Female Hitch
PTO Shaft
Locking Collar
Yoke