Walker IMPLEMENT HITCH SB6670 - Manual (Page 41)

Operating Instructions
41
The following list of items should be checked if a pat-
tern of clogging begins to develop. All of these items
are capable of causing clogging.
•
Check that the inside of the snowblower housing
is clean and free of snow and/or ice buildup.
•
Check that the auger is in good condition and not
bent, both the auger flighting and the center pad-
dles.
•
Check the inside of the blower spout for smooth-
ness and freedom of obstruction.
Remember, anything that restricts airflow or materi-
al flow along the entire path from the auger to the
blower spout can cause clogging.
DEBRIS BLOWER CONTROLS
Chute Rotation Handle
The chute rotation handle is located on the rear of
the debris blower, on the upper RH side of the im-
peller housing. The chute rotates in a 230 degree
arc, by cranking the rotation handle. Turning the
handle clockwise rotates the chute clockwise.
Turning the handle counterclockwise rotates the
chute counterclockwise.
Chute Rotation Handle
Deflector Position Control Knob
Set the angle of the deflector according to the dis-
tance the debris must be thrown. To adjust the de-
flector angle, loosen the knob on the RH side of the
deflector, slide the deflector to the required angle,
and securely retighten the knob.
Deflector Position Control Knob
DEBRIS BLOWER OPERATION
Raising and Lowering the Debris Blower
Refer to Implement Lift Switch in this section.
DANGER
DO NOT attempt to unclog the snowblow-
er or make any adjustments with the trac-
tor engine running. Disengage the PTO
clutch, stop the engine, and remove the
ignition key.
DANGER
NEVER place hands in the blower spout.
DO NOT use hands or feet to unclog the
snowblower. Use a short stick or similar
tool to remove any clogged material.
CAUTION
Before operating the debris blower, read
and understand all
Safety Instructions and
Operating Instructions.
Chute Rotation
Handle
Deflector Position
Control Knob