Weider WESY29520 - Manual (Page 12)

12
23. Locate the Leg Press Cable (95). Attach the
Cable inside the Left Leg (36) with a 3/8” x 2 3/4”
Bolt (81), two 3/8” Washers (75), two Long
Spacers (80), and a 3/8” Nylon Locknut (70).
24. Wrap the Leg Press Cable (95) around a 3 1/2”
Pulley (38). Attach the Pulley inside the Leg
Press Frame (30) with a 3/8” x 2 3/4” Bolt (81),
two 3/8” Washers (75), two 1/2” Spacers (34),
and a 3/8” Nylon Locknut (70).
22. Attach the end of the High Cable (45) to the
Small “U”-Bracket (79) with a 1/4” Washer (35)
and a 1/4” Nylon Locknut (65). Note: Do not
completely tighten the Nylon Locknut; it
should be threaded only two turns onto the
end of the Cable, as shown in the inset draw-
ing.
Attach the Small “U”-Bracket (79) to the Weight
Tube (82) with a 5/16” x 1 3/4” Bolt (69) and a
5/16” Nylon Locknut (71). Do not overtighten
the Locknut; the Weight Tube should be able
to pivot in the “U”-Bracket.
21. Wrap the High Cable (45) around a 3 1/2” Pulley
(38). Attach the Pulley at the forward hole, inside
of the bracket on the Center Top Frame (14) with
a 3/8” x 1 3/4” Bolt (66) and a 3/8” Nylon Locknut
(70).
38
45
14
70
66
21
82
69
65
35
45
79
71
22
81
80
80
70
75
36
75
95
34 34
75
75
70
95
81
30
38
23
24
45
65