Weider WESY29520 - Manual (Page 9)

9
13. Lubricate a 3/8” x 2” Bolt (62) with grease. Attach
the Pivot Bracket (48) to the Right Butterfly Arm
(11) with the Bolt and a 3/8” Nylon Jamnut (50).
Do not overtighten the Locknut; the Pivot
Bracket must be able to pivot easily.
Press a 1 1/2” x 2” Inner Cap (23) into the indicat-
ed end of the Right Butterfly Arm (11). Wet the
bottom end of the Arm with soapy water. Slide a
Large Foam Pad (19) onto the Arm.
Slide a Foam Grip (76) onto a Press Handle (12).
Press a 1” Round Inner Cap (24) into the end of
the Handle. Attach the Handle to the Right
Butterfly Arm (11) with two 5/16” x 3/4” Button
Head Bolts (64).
Slide the Large Foam Pad (19) down so that the
bottom of the Foam Pad is even with the bottom
of the Right Butterfly Arm (11).
Repeat this step with the Left Butterfly Arm
(10).
11. Press the two Weight Guide Bushings (44) into
the Center Top Frame (14). Slide the Center Top
Frame onto the Weight Guides (20).
Attach the Center Top Frame (14) to the Right
Top Frame (8) with two 5/16” x 2 3/4” Bolts (60),
two 5/16” Washers (26), and two 5/16” Nylon
Locknuts (71).
Attach the Center Top Frame (14) to the Left Top
Frame (3) with two 5/16” x 2 3/4” Bolts (60), two
5/16” Washers (26), and two 5/16” Nylon
Locknuts (71).
Tighten all of the 5/16” Nylon Locknuts (71)
used in steps 3–11.
26 26
26
71
71
14
8
3
44
20
60
60
71
71
11
22
70
8
9
61
68
53
53
Lubricate
12
64
64
76 19
10
12
11
50
48
62
24
23
13
12. Press a 2” x 2 1/2” Inner Cap (22) into the
Butterfly Frame (9).
Insert the two Locking Pins (53) into the Butterfly
Frame (9). Attach the tether on the Pins to the
Butterfly Frame with a #8 x 3/4” Screw (68). Do
not fully tighten the Screw.
Lubricate a 3/8” x 3” Bolt (61) with grease. Attach
the Butterfly Frame (9) to the Right Top Frame (8)
with the Bolt and a 3/8” Nylon Locknut (70). Do
not overtighten the Locknut; the Butterfly
Frame must be able to pivot easily.
ARM ASSEMBLY
Lubricate