Weider WESY81081 - Manual (Page 14)

14
28. Wrap the Long Cable (2) around a 3 1/2Ó Pulley (35)
in the direction shown. Attach the Pulley to the Front
Upright (42) with a 3/8Ó x 3 1/2Ó Bolt (54), a Cable
Trap (66), a 3/8Ó Flat Washer (55) and a 3/8Ó Nylon
Jamnut (57).
Attach the closed loop on the end of the Long Cable
(2) onto the Eyebolt (44) with a Cable Clip (73). Note:
Cable Clips are located in the parts bag labeled
ÒSEAT ASSEMBLY.Ó
28
12
2
73
44
54
66
29. Locate and open the parts bag labeled ÒSEAT
ASSEMBLY.Ó
Attach the Backrest (41) to the Front Upright (42) with
two 1/4Ó x 2 1/2Ó Screws.
29 Seat Assembly
41
43
43
42
35
42
57
55
30. Insert the 1/4Ó x 2Ó Carriage Bolt (38) into the center
hole in the Seat Plate (37). Attach the Seat Plate to
the Seat (13) with two 1/4Ó x 1/2Ó Screws (17).
Insert the 1/4Ó x 2Ó Carriage Bolt (38) into the indicat-
ed hole in the Seat Frame (36). Tighten a 1/4Ó Nylon
Locknut (82) with a 1/4Ó Flat Washer (81) onto the
Carriage Bolt.
Attach the other end of the Seat (13) to the Seat
Frame (36) with a 1/4Ó Flat Washer (81) and a 1/4Ó x
2Ó Bolt (71).
30
37
17
82
81
36
13
38
81
71