Weider WESY81081 - Manual (Page 7)

7
4. Set four Weight Bumpers (19) onto the Base (8) and
align them with the indicated holes.
Insert both Weight Guides (23) through the Weight
Bumpers (19) and the holes in the Base (8).
Slide eight Weights (26) onto the Weight Guides (23).
Make sure all of the Weights are turned so the pin
grooves are on the same side and are oriented as
shown on the drawing.
4
19
19
8
23
26
Pin
Grooves
5. Press the Weight Tube Bumper (64) into the end of
the Weight Tube (25).
Insert the Weight Tube (25) into the stack of Weights
(26). Make sure the pin on the Weight Tube is
resting in the pin groove in the upper Weight.
Lubricate the insides of the holes in the Top Weight
(16).
With the slot facing down, slide the Top Weight onto
the Weight Guides and set it on the stack of Weights
(26).
5
6. Slide two 5/16Ó Flat Washers (56) onto two
5/16Ó x 2 3/4Ó Bolts (67).
Place the Top Frame (1) on top of the Front Upright
(42) and align the indicated holes with the holes in
the bracket (C) on the Upright.
Insert the 5/16Ó x 2 3/4Ó Bolts (67) through the Top
Frame (1) and the bracket (C) on the Front Upright
(42). Hand tighten a 5/16Ó Nylon Locknut (53) onto
each Bolt.
Do not tighten the Locknuts yet.
6
16
25
26
64
Pin
Groove
Pin
Slot
53
53
67
56
56
42
1
C