Weider WESY81081 - Manual (Page 6)

6
1. Before beginning assembly, make sure you have
read and understood the information on page 5.
Locate and open the parts bag labeled ÒFRAME
ASSEMBLY.Ó
Press a 2Ó Square Outer Cap (51) onto each end of
the Stabilizer (5).
Insert two 5/16Ó x 2 3/4Ó Carriage Bolts (14) up
through the Stabilizer (5) and place it flat on the floor.
1
2. Press a 2Ó Square Inner Cap (21) into the end of the
Base (8).
Insert two 5/16Ó x 2 1/2Ó Carriage Bolts (52) up
through the Base (8).
Place the Base (8) on the floor with the holes in the
mounting bracket (A) over the Carriage Bolts (14) in
the Stabilizer (5).
2
Frame Assembly
51
51
14
5
21
8
52
14
5
A
3. Press a 1Ó x 2Ó Inner Cap (11) into the top of the Rear
Upright (18).
Slide the Rear Upright (18) onto the 5/16Ó x 2 3/4Ó
Carriage Bolts (14) in the Stabilizer (5). Hand tighten
a 5/16Ó Nylon Locknut (53) onto each Carriage Bolt.
Do not tighten the Nylon Locknuts yet. Make sure
the Upright is oriented as shown. The wide side
of the bracket (B) on the lower end of the Upright
(18) must be facing the front of the unit.
Slide the Front Upright (42) onto the 5/16Ó x 2 1/2Ó
Carriage Bolts (52) in the Base (8). Hand tighten a
5/16Ó Nylon Locknut (53) onto each Carriage Bolt.
CAUTION: Make sure the Upright is oriented as
shown. The indicated holes must be closer to the
rear of the unit.
Do not tighten the Nylon Locknuts yet.
3
53
53
53
53
B
52
11
5
8
18 42
14
Holes