Weider WESY81081 - Manual (Page 19)

19
Tightening the Cables
Woven cable, the type of cable used on the home gym
system, can stretch slightly when it is first used. If there is
slack in the Cables before resistance is felt, the Cables
should be tightened.
To tighten the Cables, insert the Weight Pin (39, not
shown) between the third and the fourth Weight, counting
from the top. See ÒChanging the Weight SettingÓ on page
17 for instructions on moving the Weight Pin.
Loosen the 5/16Ó Plain Nut (32) holding the Eyebolt (44)
to the Leg Lever (29). Tighten the Eyebolt a couple of
turns until the Cables feel tighter. Tighten the Plain Nut to
prevent the Eyebolt from turning.
32
44
29
1
Additional slack can be removed by moving the ÒVÓ-Pulley
(6) to one of the other holes in the bracket (P) on the
Seat Frame (36). To do this, remove the 3/8Ó x 3 1/4Ó Bolt
(69), Cable Trap (66), 3/8Ó Flat Washer (55) and 3/8Ó
Nylon Locknut (63). Move the ÒVÓ-Pulley and re-attach it
with the Bolt, Washer, Cable Trap and Locknut.
Note: If a Cable tends to slip off the Pulleys often, the
Cable may have become twisted. Remove the Cable
and re-install it.
If the Cables need to be replaced, see ORDERING
REPLACEMENT PARTS on the back cover of this manual.
36
P
69
55
6
63
66
1
Trouble-shooting and Maintenance
Inspect and tighten all parts each time you use the home gym system. Replace any worn parts
immediately. The home gym system can be cleaned using a damp cloth and mild non-abrasive
detergent. Do not use solvents.