Weider XR20 - Manual (Page 10)

18
15
23
20
15
66 68
50
48
6
21
7
16
17
CABLE ASSEMBL
Y
10
15. Route the Long Cable (23) around a ÒVÓ-
Pulley (6). Using a 3/8Ó x 2 1/2Ó Bolt (7) and a
3/8Ó Nylon Locknut (21), attach the ÒVÓ-Pulley
(6) and a Long Cable Trap (50) to the Right
Arm (48). Be sure that the Cable is in the
groove of the Pulley and that the Long
Cable Trap (50) is positioned to hold the
Cable in place.
16. See the inset drawing. Using a 5/16Ó x 5Ó
Bolt (68) and a 5/16Ó Nylon Locknut (3),
attach the Pulley Bracket (20) to the indicated
bracket on the Top Frame (55). Note: The
Pulley Bracket is pre-assembled with a 3
1/2Ó Pulley (15) and a Cable Trap (66).
Route the Long Cable (23) around the 3 1/2Ó
Pulley (15) attached to the Pulley Bracket
(20). Be sure that the Cable is in the
groove of the Pulley and that the Cable
Trap (66) is turned to hold the Cable in
place. Make sure that the 5/16Ó x 5Ó Bolt (68)
is properly tightened and that the Pulley
Bracket (20) can move freely.
17. Remove the 3 1/2Ó Pulley (15) from the pre-
assembled Long ÒUÓ Bracket (57). See the
inset drawing. Wrap the Long Cable (23)
around the Pulley in the direction shown.
Attach the Pulley (15) and a Cable Trap (66)
to the indicated hole in the Long ÒUÓ Bracket
(57) with a 3/8Ó x 2Ó Bolt (12) and a 3/8Ó
Nylon Locknut (21). Be sure that the Cable
is in the groove of the Pulley and that the
Cable and Pulley move smoothly.
18. Wrap the Long Cable (23) around a 3 1/2Ó
Pulley (15). Using a 3/8Ó x 1 3/4Ó Bolt (85)
and a 3/8Ó Nylon Locknut (21), attach the
Pulley to the indicated bracket on the Top
Frame (55). Be sure that the Cable is in the
groove of the Pulley and that the Cable
and Pulley move smoothly.
23
21
57
15
66
23
23
85
15
21
Bracket
55
23
12
68
20
55
3