Weider XR20 - Manual (Page 20)

20
TROUBLE-SHOOTING AND MAINTENANCE
Inspect and tighten all parts each time you use the home gym system. Replace any worn parts immediately. The
home gym system can be cleaned using a damp cloth and mild non-abrasive detergent. Do not use solvents.
TIGHTENING THE CABLES
Woven cable, the type of cable used on the home
gym system, can stretch slightly when it is first used.
If there is slack in the cables before resistance is felt,
the cables should be tightened.
Slack can be removed from the cables by tightening
the Long Cable (23) (see drawing 1). To tighten the
Long Cable, first loosen the 1/2Ó Plain Nut (81). Next
tighten the end of the Long Cable further into the
Weight Tube (63). Tighten the 1/2Ó Plain Nut against
the 1/2Ó Flat Washer (82).After tightening the Long
Cable, you must also tighten the 1/2Ó Plain Nut (81)
against the 1/2Ó Flat Washer (82).
To remove slack from the Medium Cable (58), tighten
the 1/2Ó Nylon Locknut (2) on the Long ÒUÓ Bracket
(57). To do this you may need to remove the Long
Cable (23) from the Weight Tube (63) or remove the 3
1/2Ó Pulley (15) from the Long ÒUÓ-Bracket (57).
Additional slack can be removed by moving the 3 1/2Ó
Pulley (15) to the other hole in the Long ÒUÓ-Bracket
(57). Remove the 3/8Ó Nylon Locknut (21) and the
3/8Ó x 2Ó Bolt (12) from the Cable Trap (66), Pulley,
and Long ÒUÓ-Bracket. Re-attach the Pulley and
Cable Trap. Be sure that the Cable Trap is in the
proper position and that the Cable and Pulley
move smoothly.
Make sure that the cables are not too tight, or the Top
Weight (76) will be lifted off the weight stack.
If the cables need to be replaced, see the back cover
of this manual.
57
66
15
2 58
21
23
2
23
12
81
76
82
63
1