Weider XR20 - Manual (Page 15)

33. Press 3/4Ó Round Inner Caps (34) into the
ends of both Pad Tubes (28).
Insert one Pad Tube (28) into the Seat Frame
(36). Slide a Foam Pad (30) onto each end of
the Pad Tube.
Insert the other Pad Tube (28) into the Leg
Lever (29). Slide a Foam Pad (30) onto each
end of the Pad Tube.
See the left inset drawing. Insert the head of
the 5/16Ó x 1 1/4Ó Carriage Bolt (72) into the
keyhole in the Leg Lever (29). Be sure that
the shoulder of the Carriage Bolt is firmly
seated in the square part of the keyhole.
See the right inset drawing. Orient the Short
Cable (35) and the Curl Bar (77) as shown.
This is the storage position for the Curl Bar.
34. Attach the Curl Pad (80) to the Curl Frame
(79) with two 1/4Ó x 3/4Ó Screws (18).
Insert a 1 1/2Ó Square Inner Cap (32) into
each end of the Curl Frame (79).
35. Attach the Curl Frame (79) to the Seat Frame
(36) by inserting the pin on the Curl Frame
into the upper hole in the Seat Frame. Secure
the Curl Frame with the Curl Knob (78).
15
35
78
79 Pin
34
33
36
18
30
34
34
28
29
80
30
LEG LEVER
ASSEMBL
Y
CURL
FRAME ASSEMBL
Y
32
36
32
79
18
77
35
29
72
Keyhole