Wolf ICBCT36EU - Manual (Page 16)

16
W O L F E L E C T R I C C O O K T O P U S E & C A R E
B R I D G E - Z O N E E L E M E N T
When activated, the bridge-zone element
creates an oblong heating area for use with a
griddle, open roaster or fish poacher.
To turn on the bridge-zone heating element,
touch the
touch pad of either control
that corresponds with the bridge zone element.
Refer to illustration below.
Set the heat setting for either the front or
rear element as described on page 15.
Touch . The bridge element and the
element that is not turned on will both be
set to the same heat setting as the first
element. Lights will remain on under the
front, rear and bridge element touch pads
to indicate the bridge-zone elements are on.
Changing the heat setting of the entire
bridge-zone element is done the same as
for a single element. All three elements
maintain the same heat setting.
Touch again to turn off the bridge
element. The light under the bridge element
touch pad will go out. The front and rear
elements will remain at the current heat
setting and will become independent of one
another.
The illustrations below show the control panel
of Model ICBCT36E.
C O O K T O P O P E R A T I O N
T R I P L E - Z O N E E L E M E N T
To turn on a triple-zone heating element,
touch the
touch pad of the control that
corresponds with the triple-zone element.
Refer to the illustration below.
Set the heat setting for the inner element
zone as described on page 15.
Touch and the middle element
zone will be turned on to the same heat
setting as the inner zone. A light will remain
on under the
touch pad to indicate
the middle element zone is on.
Touch and the outer element
zone will be turned on to the same heat
setting as the inner and middle element
zones.
A light will remain on under the
touch pad to indicate the outer element
zone is on.
Changing the heat setting to the entire
triple-zone element is the same as for a
single element.
If is turned on directly, will
automatically be turned on. Similarly, if all
three zones are turned on, turning off
will automatically turn off
.
When is turned on, lights under the
other two zones will dim. This is normal.
Triple-zone element Dual-zone element
Triple-zone
element control Dual-zone
element control
Bridge-zone element
Bridge-zone
element control