Westell Technologies 36R570 - Manual (Page 7)

ADSL WireSpeed Pro 36R570 Proxy Router
User Guide
030-300153A 7 WireSpeed Pro Installation
6. The Link LED should be solid green indicating that the CPE connection has been made.
7. During use, a pulsing yellow Activity LED indicates that data is being transmitted and received on the Ethernet
interface.
8. Proceed to page 16, “Setting Up Your WebShare Account” to configure the software.
ADSL LINE
ETHERNET
POWER
CONNECTOR
ON/OFF
SWITCH
Figure 1. WireSpeed Pro Single-User Setup Connections
Multiple-User Setup
Refer to the wiring diagrams in Figure 2 and Figure 3.
1. Connect the power supply cord to the power connector on the side of the WireSpeed Pro and plug into a power
receptacle.
2. Connect a standard RJ-11 telephone cable from the LINE connector to the ADSL-equipped phone line.
3. Obtain a multi-port Ethernet Hub (available separately). Ensure that the hub includes enough Ethernet ports to
meet the requirements of the network.
4. Connect the straight 10Base-T cable (included with this package) to the jack labeled ETHERNET on the side of
the unit to the jack-designated uplink on the Ethernet Hub. With some Ethernet Hubs, a crossover cable (available
separately) may be required. Please see the documentation included with the selected Ethernet hub.
5. Connect each additional PC to the Ethernet hub.
6. Turn the power switch ON.