Program menus, Service manual – combo brewer – Wibur Curtis Company PTT3 User Manual

Page 8

Advertising
background image

PROGRAM MENUS

Tea Recipes

Program Menus

8

BREWING INSTRUCTIONS – TEA

1. Brewer should be ON (Confirm at rear toggle switch, then press ON/OFF button) and Ready-to-Brew displayed.

2. Make sure deck is folded down and tea container is in place.

IMPORTANT – Tea container must be pushed all the way to the back to ensure the safety switch is engaged and tea brewing can start.

3. Place filter in brew

basket. Pour leaf tea

into basket marked

ICED TEA or TROPICAL

TEA.

4. Slide brew cone into

brew rails. Place tea

container under brew

cone.

6. Press the TEA

BREW button.

5. Slide container in

to activate switch

behind folded

coffee deck.

Service Manual – Combo Brewer

To Go Into Programming

Turn off (dark display) by pressing ON/OFF button (yellow). Press and hold BREW button 4 (green) and then press and release ON/OFF button (yellow).

Continue holding BREW button. Display will read

, wait until

is displayed Enter the 4-digit access code, the digits 1-4 corre-

spond to the buttons (see illustration below).

The default code set at the factory is 1-2-3-4. Then

will be displayed.

Your Curtis ADS System is Factory Pre-Set for Optimum Performance.

After connection to water and power; the rear toggle switch must be on. You will hear a beep sound, indicating power is available to the controller.

The control displays

. Press ON/OFF button and the screen will display

. After three seconds,

is displayed.

Water will fill the tank (approximately 2-3 minutes depending on water flow rate). When the proper level is reached

will appear on the

screen. It takes approximately 20 minutes to reach setpoint temperature of 204°F.

Control will display

when temperature reaches the setpoint (204°F). Unit is now ready to brew.

<Coffee/TeaBrewer>

CURTIS

CURTIS

ENTER CODE

– – – –

PROGRAM MENUS

< SELECT >

CURTIS

READY TO BREW

ENTERING PROGRAM

MODE

All programming selections are performed with the three center buttons.

The symbols below the buttons are:

Scroll LEFT

SELECTION or ENTER to save new parameter

Scroll RIGHT

4

3

1

2

CURTIS

FILLING

CURTIS

HEATING

Brew Volume (Factory set to 3.0 Gallons)

Selecting Brew by Volume or Brew by Time depends on whether you know your brew time before starting.

From Program Menus press > display will now show the next feature.

Tea Recipe (Factory set to Standard Tea)

Pressto Select. Press < or > to toggle between STANDARD TEA, TROPICAL TEA and RECIPE #3 76/308.

Set and exit by pressing .

Continued on Page 9

Advertising