Weider WEBE4496.0 - Manual (Page 11)

11
12. Attach a Foot (78) to the Rear Base (25) with an
M4 x 16mm Self-tapping Screw (102) and an M4
Washer (87).
Insert two M10 x 70mm Bolts (116) up through
the Foot Plate (54) and the Rear Base (25). Place
tape over the Bolt heads to hold them in place
13. Attach a Front Base (26) to the Rear Base (25)
with two M10 x 81mm Bolts (100), four M10
Washers (96), and two M10 Nylon Locknuts (94).
Do not tighten the Nylon Locknuts yet.
Repeat this step for the other Front Base (26).
13
12
26
25
116
54
78
87
102
94
96
96
26
100
25
14. Orient a Front Upright (27) so that it leans toward
the Foot Plate (54). Attach the Front Upright to a
Front Base (26) with the two M10 x 81mm Bolts
(100) and two M10 Nylon Locknuts (94).
Do not
tighten the Nylon Locknuts yet.
Repeat this step for the other Front
Upright (not shown) and Front Base (26).
14
94
94
54
27
26
26
100