Weider WEBE4496.0 - Manual (Page 18)

18
33. Attach the Cable (66) to the Weight Carriage (55)
with an M10 x 40mm Button Bolt (109), an M10
Washer (96), and a 23mm Spacer (99).
Make
sure the flat edge of the Cable is against the
Weight Carriage.
34. Remove the M4 x 12mm Self-tapping Screw
(123) and the Swivel Arm (48).
Locate the High Cable (131). Insert the Cable
under the bar in the Swivel Arm (48) and route
the Cable through the Swivel Arm, into the Right
Front Frame (33), and out the slot in the Right
Front Frame.
Make sure the Cable is routed
under the bar in the Swivel Arm and to the
inside of the indicated bolt.
Attach the Swivle Arm (48) to the Right Front
Frame (33) with the M4 x 12mm Self-tapping
Screw (123). Attach a Small Pulley (59), two
16mm x 6mm Spacers (91), an Outer Pulley
Cover (63), and an Inner Pulley Cover (82) to the
Swivel Arm with an M10 x 60mm Bolt (117), two
M10 Washers (96), and an M10 Nylon Locknut
(94).
Make sure the Spacers are inside the
Swivel Arm.
34
99
96
109
66
55
63
Bar
131
33
96
117
91
91
96
94
59
48
123
The Cable must
pass on this
side of the Bolt.
82
33
32. Wrap the Cable (66) over the Large Pulley (60).
Attach the Large Pulley inside the Rear Upright
(30) with an M10 x 65mm Bolt (124), two M10
Washers (96), and an M10 Nylon Locknut (94).
32
66
60
30
96
96
94
124