Weider WEBE4496.0 - Manual (Page 20)

20
39. Remove the M4 x 12mm Self-tapping Screw
(123) and the Swivel Arm (48) from the Left Front
Frame (32). Route the Cable (131) through the
slot in the Left Front Frame and through the
Swivel Arm.
Make sure the Cable is routed
under the bar in the Swivel Arm.
Attach the Swivel Arm (48) to the Left Front
Frame (32) with the M4 x 12mm Self-tapping
Screw (123).
Position the Bottom Plate (65) and the Top Plate
(64) around the Cable (131) as shown. Attach the
Bottom and Top Plates to the Left Front Frame
(32) with two M4 x 16mm Self-tapping Screws
(102).
40. Attach a Small Pulley (59), two 16mm x 6mm
Spacers (91), an Outer Pulley Cover (63), and an
Inner Pulley Cover (82) to the Swivel Arm (48)
with an M10 x 60mm Bolt (117), two M10
Washers (96), and an M10 Nylon Locknut (94).
Make sure the Spacers are inside the Swivel
Arm.
39
40
32
48
64
65
131
102
123
Bar
82
48
91
91
59 63
94
96
96
131
117
38. Wrap the Cable (131) over a Small Pulley (59).
Attach the Small Pulley and a Cable Trap (76) to
the inside of the Rear Frame (31) with an M10 x
45mm Bolt (104) and an M10 Nylon Locknut (94).
38
104
59
131
76
31
94
The Cable
must pass
on this side
of the Bolt.