Weider 240 TC - Manual (Page 12)

12
17. Route the Cable (21) through the top of the Lat
Tower (14); make sure that the Cable is
under the storage hook.
Next, wrap the Cable (21) over the Pulley (22),
and attach the Pulley inside the Lat Tower (14)
with an M10 x 60mm Bolt (57), two M10 Black
Washers (64), two 16mm x 10mm Spacers
(52), and an M10 Black Locknut (66).
Insert an M10 x 20mm Bolt (63) into the bracket
on the Weight Carriage (15).
Slide the Weight Carriage (15) onto the Lat
Tower (14).
Then, slide the end of the Cable (21) onto the
M10 x 20mm Bolt (63) and tighten an M10
Black Locknut (66) onto the Bolt.
17
21
Storage
Hook
66 64
64
52
52
22
14
57
63
15
66
18. Make sure that all parts are properly tightened before you use the weight bench. The use of all
remaining parts will be explained in ADJUSTMENT, starting on page 13.