Weider 240 TC - Manual (Page 7)

7
3. Attach the Front Leg (2) to the Front Base (3)
with two M10 x 52mm Carriage Bolts (74) and
two M10 Black Locknuts (66).
3
66
66
74
2
3
4. Attach the Front Leg (2) to the Frame (1) with
two M10 x 60mm Bolts (57), two M10 x 55mm
Bolts (59), six M10 Black Washers (64), and
four M10 Black Locknuts (66).
4
2
66
64
64
64
66
59
57
1
5. Apply some of the included grease to an M10 x
70mm Bolt (71).
Attach the Frame (1) to the upper set of holes in
the bracket on the Crossbar (12) with the M10 x
70mm Bolt (71) and an M10 Black Locknut (66).
Then, tighten the Frame Knob (37) into the
bracket on the Crossbar (12) and the Frame (1).
See the inset drawing. Insert the Crossbar Pin
(29) into the lower set of holes in the Crossbar
(12).
Attach the Crossbar Pin (29) to the Crossbar
(12) with an M4 x 16mm Self-tapping Screw
(75).
71 Bracket
Grease
37
1
66
12
5
29
12
75