Weider WEBE0878.0 - Manual (Page 9)

9
8. Orient the two Pivot Bars (14) so that the
Pulleys (22) face away from the Center Frame
(13). Then, insert the Pivot Bars into the brack-
ets on the ends of the Center Frame, and
engage the pins on the brackets into the cen-
ter adjustment holes in the Pivot Bars.
Insert the two Pulleys (22) down into the slots
in the Saddle Plates (18).
See step 2. Tighten the four M8 Locknuts (54).
9. Pull the Short Adjustment Knob (19), and
insert the end of the Adjustment Frame (7) a
few inches into the Backrest Frame (6).
See the inset drawing. Press the round tab
on the Backrest Frame Bushing (25), and
press the Backrest Frame Bushing into the
Backrest Frame (6). Make sure that the
round tab is in the indicated hole in the
Backrest Frame.
Next, insert the Adjustment Frame (7) farther
into the Backrest Frame (6), and engage the
Short Adjustment Knob (19) into one of the
adjustment holes in the Adjustment Frame.
Then, insert the Pin (24) into the Backrest
Frame (6) and the Adjustment Frame (7), and
attach the Pin Clip (63) to the Pin.
Use the inversion system with the Adjustment
Frame (7) adjusted to a few different lengths to
determine which length is the best for you.
8
14
22
22
13
18
14
18
Pin
Pin
9
7
19
6
24
63
6
25
Tab
Hole