Western Telematic RMM-288 - Manual (Page 11)

* &D2 Normal DTR operations
&D3 Resets on receipt of DTR
&Fn Loads a read-only (non-programmable) factory configuration.
&F0 Generic Template
* &F1 Hardware flow control template
&F2 Software flow control template
&Gn Sets Guard Tone
* &G0 No guard tone (U.S.A. and Canada).
&G1 550 Hz guard tone (some European countries); requires B0 setting.
&G2 1800 Hz guard tone (U.K.); requires B0 setting.
&Hn Sets Transmit Data (TD) flow control.
&H0 Flow control disabled.
* &H1 Hardware flow control, Clear to Send (CTS).
&H2 Software flow control, XON/XOFF.
&H3 Hardware and Software flow control.
&In Sets Receive Data (RD) software flow control (see also &Rn).
* &I0 Software flow control disabled.
&I1 XON/XOFF signals to your modem and remote system.
&I2 XON/XOFF signals to your modem only.
&Kn Enables/disables data compression.
&K0 Data compression disabled
* &K1 Auto enable/disable
&K2 Data compression enabled
&K3 MNP5 compression disabled
&Mn Sets Error Control (ARQ for connection at 1200 bps and higher.
&M0 Normal mode, error control disabled
&M1 Reserved
&M2 Reserved
&M3 Reserved
* &M4 Normal/ARQ
RMM Rack Mount Modem; User's Guide
file:///C|/WEBPAGE/guides/rmm/rmm_manl.htm (11 of 21) [2/7/2000 10:55:43 AM]