Western Telematic RMM-288 - Manual (Page 14)

&W0 Modifies the NVRAM 0 template (Y0).
&W1 Modifies the NVRAM 1 template (Y1).
&Yn Sets break handling
&Y0 Destructive, but doesn't send break.
* &Y1 Destructive, expedited
&Y2 Non-destructive, expedited
&Zn=s Writes phone number s to NVRAM at position n (n = 0 - 3).
&Zn=L Writes the last executed dial string to NVRAM at position n (n = 0 - 3).
&Zn? Displays the phone number stored at position n (n = 0 - 3).
&ZL? Displays the last executed dial string.
+++ Escapes to online Command Mode.
6. S-Registers
Note: To change a setting, use the ATSr=n command, where r is the register and n is a
decimal value from zero to 255 (unless otherwise indicated).
Register Default Function
S0 1 Sets the number of rings on which to answer in Auto Answer mode.
When set to 0 (zero), Auto Answer is disabled. Auto Answer is also
controlled by DIP Switch 5.
S1 0 Counts and stores the number of rings from an incoming call. Register
S0 must be greater than 0.
S2 43 Stores the ASCII decimal code for the escape code character. The
default character is +. Any value between 128 and 255 will disable the
escape code.
S3 13 Stores the ASCII code for the Carriage Return character. Valid range
is 0 to 127.
S4 10 Stores the ASCII decimal code for the Line Feed character. Valid
range is 0 to 127
S5 8 Stores the ASCII decimal code for the Backspace character. Any value
between 128 and 255 will disable the Backspace key's delete function.
RMM Rack Mount Modem; User's Guide
file:///C|/WEBPAGE/guides/rmm/rmm_manl.htm (14 of 21) [2/7/2000 10:55:44 AM]