Zanussi ZCM 700 X - Manual (Page 26)

26
Splash back Assembly
A stainless steel splash back is supplied with the
appliance. This is meant to be fitted on the rear edge
of the cooker's hob. The splash back is inserted into
the polystyrene upper part of the package.
1. Carefully clean the hob top.
2. A foam rubber gasket is supplied into the
instruction book envelope.
3. After cleaning the hob from possible grease
and film residuals left, fix the gasket on the
rear part of the hob, paying attention not to
close the fan slots (Fig. 4).
4. Take the splash back out of the envelope
and remove the protective film.
5. Insert the splash back into the proper hinges
in the rear part of the hob (Fig. 5).
6. Fix the splash back with the supplied
screws (Fig. 6).
FO 2285 Fig. 5
FO 2285
Fig. 6
Fig. 4
FO 2347
☞