Fitting the stability bracket (not supplied) – Zanussi ZCM 700 X User Manual

Page 28

Advertising
background image

28

REAR W

ALL

165 mm

Fitting the Stability Bracket
(Not supplied)

If the cooker has to be installed with a flexible supply
pipe, it is necessary that a stability device is fitted.

If a stability bracket should be fitted by the installer,
these instructions should be read in conjunction with
the leaflet packed with the stability bracket.

1. Place the cooker in its intended position

and mark the cooker height.

2. Mark 165mm below the cooker height. This

is the position of the stability bracket.

3. Fix a large type of stability bracket (using

two of the provided five fixing holes) to
the rear wall (see the picture below).

4. Pull the cooker towards the rear wall as

shown in the diagram. The stability bracket
should then come into contact with the rear
panel of the cooker (see diagram).

Should the stability bracket currently installed not
allow the cooker to stand correctly, ask the installer
to replace it with the correct type.

Advertising