Yamaha DG60FX-112 - Manual (Page 12)

12
Using the DG60FX-112
First, connect a guitar to the DG60FX-112 and try some sounds.
■ Produce Sound
1. Before connecting, turn off the power on the
DG60FX-112 and connect a guitar to either the
LOW or HIGH INPUT jack.
High output guitars should be connected to the
jack labeled LOW while low output guitars should
be connected to the jack labeled HIGH.
2. After rotating the OUTPUT knob to the “0” posi-
tion, turn the POWER switch (POWER) to ON
(
).
Turning the POWER switch ON when the OUTPUT
knob is turned up may result in damage to devices
such as amplifier, speaker, headphone, etc., or
cause unexpected accidents like damage to your
hearing due to a high volume setting.
3. A 3-digit number such as “ 011 ” will appear on
the display.
Note: When the patch’s number is shown on the
display the device is in a condition called the
PLAY MODE. When in the PLAY MODE, it is
possible to select a patch and use the knobs
or buttons to change settings to play.
For now use this patch to try and produce some
sound.
4. Play a chord on the guitar and rotate the OUT-
PUT knob to the right to control the volume.
The numbers (Group number: 0, Bank number:
1, Patch number: 1) refer to the patch that is
currently selected.
* If the peak indicator continuously lights while playing the
guitar, the level of the guitar’s input signal is too high. Either
use the INPUT jack labeled LOW or reduce the guitar’s out-
put (volume).