Yamaha DG60FX-112 - Manual (Page 27)

27
■ Wah Pedal Settings
These settings are available when the Wah Pedal
function (“
UUH ”) is selected as the controller in the
External Control settings.
Press the [UTILITY] button then set the amp select
switch to CRUNCH1 (“
UUH ” will appear on the dis-
play).
● Set the Low Frequency of the Wah Pedal
Sets the low frequency in the wah pedal’s frequency
range.
Press the [COMP] button and use the [UP]/[DOWN]
buttons to set the frequency (
150 - 500 :Hz).
● Set the High Frequency of the Wah Pedal
Sets the high frequency in the wah pedal’s frequency
range.
Press the [CHORUS] button and use the [UP]/
[DOWN] buttons to set the frequency (
1 . 5 0 -
5.00 :kHz).
● Set the Wah Pedal “Q”
Sets the frequency curve of the wah pedal.
Press the [FLANGER] button and use the [UP]/
[DOWN] buttons to select a curve (
1.00 - 5.00 ).
Utility Mode
■ The Speaker Simulator
Press the [UTILITY] button then set the amp select
switch to CRUNCH2. The current setting will appear
on the display.
Use the [UP]/[DOWN] buttons to select a speaker
simulator mode.
• GLb : The speaker simulator is always ON.
• PrG : The speaker simulator is switched ON/
OFF according to the patch setting.
• oFF : The speaker simulator is always OFF