Yamaha DG60FX-112 - Manual (Page 26)

26
Utility Mode
● Set the Parameter’s Maximum Value
Press the [TREMOLO] button and use the [UP]/
[DOWN] buttons to set the parameter’s maximum
value (the parameter’s value when the controller is
set to its maximum:
0.0 - 10.0 ).
■ EXP Pedal Settings
These settings are available when the EXP Pedal
(“
EP ”) is selected as the controller in the External
Control Settings.
Press the [UTILITY] button then set the amp select
switch to DRIVE2 (“
E.P ” will appear on the display).
● Set the Minimum Value of the EXP Pedal
Sets the minimum value that indicates the position
of the EXP Pedal.
Press the [COMP] button and use the [UP]/[DOWN]
buttons to set the position (
0 - 128 ).
You can also hold the [COMP] button and move the
EXP Pedal to set the position.
* Due to the relationship between the maximum and minimum
value, a value which results in a practical range (refer to the
illustration below) of less than 128 can not be used.
● Set the Maximum Value of the EXP Pedal
Sets the maximum value that indicates the position
of the EXP Pedal.
Press the [CHORUS] button and use the [UP]/
[DOWN] buttons to set the position (
127 - 255 ).
You can also hold the [CHORUS] button and move
the EXP Pedal to set the position.
* Due to the relationship between the maximum and minimum
value, a value which results in a practical range (refer to the
illustration below) of less than 128 can not be used.
* The value can not be set greater than that of the EXP Pedal’s
Switch Setting.
Normal Use Range
Average Position
Switch Effective Range
(Automatic Return Range)
Set the ON/OFF position of the
pedal switch within this range.
● The EXP Pedal’s Switch Setting
When the EXP Pedal is used as a wah pedal, it is
possible to switch the wah effect ON/OFF by step-
ping on the pedal. Set the pedal angle at which the
effect is switched ON/OFF.
Press the [FLANGER] button and use the [UP]/
[DOWN] buttons to set the pedal position.
You can also hold the [FLANGER] button and move
the EXP Pedal to set the position.
* The value can not be set less than that of the EXP Pedal’s
Maximun Value.
* If the value is set to “ oFF ” , the wah switch function will
be ineffective.
* The YAMAHA FC-7 foot controller is equipped with a
“fortissimo” function that allows the foot pedal to be de-
pressed beyond its average position. When your foot releases
the fully depressed pedal, the pedal will naturally return to
its average position. Setting the EXP. Pedal’s switch function
to this “fortissimo” function is convenient.
● Transmitting Control Change Numbers from
the EXP Pedal
Set the MIDI control change number that is to be
transmitted when the EXP pedal is used.
Press the [PHASER] button and use the [UP]/
[DOWN] buttons to set the control change number.
• oFF : MIDI is not transmitted
• 1 - 32 , 64 - 95 :
Control change number that is to be
transmitted.
Minimum
Value
Maximum
Value
Maximum
Adjustable
Range
Practical Effective Range
(more than 128)