ZyXEL Communications G-2000 Plus - Manual (Page 364)

ZyAIR G-2000 Plus User’s Guide
363 Chapter 35 System Maintenance and Information
Figure 206 Menu 24 System Maintenance
Menu 24 - System Maintenance
1. System Status
2. System Information and Console Port Speed
3. Log and Trace
4. Diagnostic
5. Backup Configuration
6. Restore Configuration
7. Upload Firmware
8. Command Interpreter Mode
9. Call Control
10. Time and Date Setting
11. Remote Management Setup
Enter Menu Selection Number:
Figure 207 Valid CI Commands
Copyright (c) 1994 - 2004 ZyXEL Communications Corp.
G-2000PLU> ?
Valid commands are:
sys exit device ether
poe pptp config wlan
ip ppp bridge certificates
radius 8021x radserv
G-2000PLU>
35.2 Call Control Support
The ZyAIR provides two call control functions: budget management and call history. Please
note that this menu is only applicable when Encapsulation is set to PPPoE in menu 4 or
menu 11.1.
The budget management function allows you to set a limit on the total outgoing call time of
the ZyAIR within certain times. When the total outgoing call time exceeds the limit, the
current call will be dropped and any future outgoing calls will be blocked.
To access the call control menu, select option 9 in menu 24 to go to Menu 24.9 — System
Maintenance — Call Control, as shown in the next table.