Zanussi ZWQ 7100 SO - Manual (Page 3)

Dispenser box
Prewash
Wash
Softener (do not fill above the MAX
symbol M )
Safety information
Please read these points carefully before instal-
ling and using your appliance. Keep this user
manual with your appliance.
General safety
• Do not modify or attempt to modify this appli-
ance. This would put yourself in danger.
• Ensure that all coins, safety pins, brooches,
screws etc have been removed before start-
ing a washing programme. If left in washing,
they can seriously damage the appliance.
• Use the recommended quantity of detergent.
• Put small items together (socks, belts etc.) in
a small linen bag or pillow case.
• Unplug and close inlet hose tap after using
appliance.
• Always disconnect the power supply from
the appliance before cleaning or mainte-
nance.
• Do not machine wash clothes with ribbing,
unfinished or torn material.
Installation
• Unpack or ask for the appliance to be un-
packed immediately upon delivery. Check the
outside of the appliance is not damaged in
any way. Report all transit damage to your re-
tailer.
• Remove all transit bolts and packaging be-
fore installing the appliance.
• Connection to the water supply must be car-
ried out by a qualified plumber.
• If your domestic electrical circuit needs
adapting to allow the appliance to be plug-
ged in, use a qualified electrician.
• Ensure that, after installation, the power ca-
ble is not trapped under the appliance.
• If the appliance is installed on carpeted floor,
ensure that the carpet does not obstruct any
ventilation ducts located at the base of the
appliance.
• The appliance must be equipped with an
earthed power plug which conforms to regu-
lations.
• Before connecting your appliance to the
power supply, carefully read the instructions
in the chapter entitled “Electrical connec-
tion”.
• Replacing the power cable should only be
carried out by an authorised service engi-
neer.
• The manufacturer cannot be held responsible
for any damage resulting from incorrect in-
stallation.
Precautions to be taken against frost
If your appliance is exposed to temperatures
below 0°C, the following precautions must be
taken:
• Close the tap and disconnect the inlet hose.
• Place the end of this hose and the drain hose
in a basin on the floor.
• Select the Drain programme let it run until
the end of the cycle.
3
www.zanussi.com