Zanussi ZWQ 7100 SO - Manual (Page 9)

Problems Causes
The E20 error code ap-
pears in the display
2)
and
the “Start/Pause” pushbut-
ton flashes red
3)
:
• the drainage filter is obstructed,
• the drain hose is blocked or bent,
• the drain hose is fixed to high (see "Installation" section),
• the drainage pump is blocked,
• the standpipes blocked.
The E10 error code ap-
pears in the display
2)
and
the “Start/Pause” pushbut-
ton flashes red
3)
:
• the water tap is closed,
• the water supply has been cut off.
• a red tab appears on the water inlet hose 1)
.
The EF0 error code ap-
pears in the display
2)
and
the “Start/Pause” pushbut-
ton flashes red
3)
:
• the drainage filter is obstructed,
• the anti-flooding security system has been activated, please proceed as fol-
lows :
- close the water inlet tap,
- empty the appliance for 2 minutes before unplugging,
- call the after-sales service.
Softener runs directly into
the drum when filling the
dispenser box: • you have gone past the MAX indicator.
1) Depending on model.
2) On some models, the auditable signals can sound
3) After solving any problems, press "Start/Pause" pushbutton to restart the interrupted programme.
Detergents and Additives
Only use detergents and additives designed for
use in a washing machine. We do not recom-
mend mixing different types of detergents. This
may spoil the washing. There are no restrictions
on the use of powder detergents. Liquid deter-
gents must not be used when a prewash has been selected. For cycles without prewash,
they must be added via means of a dosing ball.
Detergent tablets or doses must be placed in
the detergent compartment of your appliance's
dispenser box.
Technical Specifications
DIMENSIONS Height
Width
Depth 850 mm
400 mm
600 mm
LINE VOLTAGE /FREQUENCY
POWER CONSUMPTION 220-230 V / 50 Hz
2300 W
WATER PRESSURE Minimum
Maximum 0,05 MPa (0,5 bar)
0,8 MPa (8 bar)
Connection to water supply Type 20/27
9
www.zanussi.com