Zanussi ZWQ 7100 SO User Manual

Page 8

Advertising
background image

Problems

Causes

The washing machine
doesn’t rinse or doesn’t
empty :

• the drain hose is blocked or bent,

• the drainage filter is obstructed,

• the out of balance detector has been activated : washing is unevenly distrib-

uted in the drum,

• the “Drain” programme or “Night Silence Plus” or “Rinse hold” option have

been selected,

• the height of the drainage U-piece is unsuitable.

You have found water
around the washing ma-
chine :

• too much detergent has caused foam to overflow,

• the detergent is unsuitable for machine washing,

• the drainage U-piece isn’t attached correctly,

• the drainage filter hasn’t been put back in place,

• the water inlet hose is leaking.

Wash is unsatisfactory :

• the detergent is unsuitable for machine washing,

• there is too much washing in the drum,

• the wash cycle is unsuitable,

• there isn’t enough detergent.

The appliance vibrates, is
noisy :

• all packaging have not been removed from the appliance (see installation

section),

• the appliance isn’t level and is unbalanced,

• the appliance is too close to the wall or furniture,

• washing is unevenly distributed in the drum,

• the load is too small.

The wash cycle is much
too long :

• the water inlet filters are dirty,

• the power or water supply has been cut off,

• the motor overheating detector has been activated,

• the water inlet temperature is lower than usual,

• the foam detection security system has been activated (too much detergent)

and the washing machine has begun draining the foam,

• the out of balance detector has been activated: an extra phase has been

added to distribute washing more evenly in the drum.

The washing machine
stops during a wash cy-
cle :

• the water or electricity supply is defective,

• a Rinse hold has been selected,

• the drum shutters are open.

The lid doesn’t open at the
end of the cycle :

• the temperature inside the drum is too high,

• the lid unlocks 1 - 2 minutes after the end of the cycle.

The E40 error code ap-

pears in the display

2)

and

the “Start/Pause” pushbut-

ton flashes red

3)

:

• the lid is not closed properly.

8

www.zanussi.com

Advertising