Zanussi ZWQ 7100 SO - Manual (Page 4)

• Disconnect the appliance from the power
supply by turning the programme selector to
“Stop”
.
• Unplug the appliance.
• Replace the inlet hose and drain hose.
This way, the water remaining in the hoses will
be drained away, avoiding any ice formation
which would damage your appliance.
Before turning your appliance on again, ensure
that it is installed in an area where the tempera-
ture will not fall below freezing.
Use
• Your appliance is intended for normal do-
mestic use. Do not use the appliance for
commercial or industrial purposes or for any
other purpose.
• Refer to the instructions on the label of each
item before washing.
• Do not put items into the washing machine
which have had stains removed with petrol,
alcohol, trichlorethylen etc. If such stain re-
movers have been used, wait until the prod-
uct has evaporated before putting these
items into the drum.
• Empty pockets and unfold items.
• This appliance is not intended for use by per-
sons (including children) with reduced physi-
cal, sensory or mental capabilities, or lack of
experience and knowledge, unless they have
been given supervision or instruction con-
cerning use of the appliance by a person re-
sponsible for their safety.
Children should be supervised to ensure that
they do not play with the appliance.
How to run a wash cycle?
Using for the first time
• Ensure the electrical and water connec-
tions comply with the installation in-
structions.
• Remove the polystyrene insert and all
other items inside the drum.
• Run an initial wash cycle at 90°C, with-
out any washing but with detergent to
clean the water tank.
Daily Use
Loading washing
A A
• Open the lid of the appliance.
• Open the drum by depressing the locking
button A 1) : The two shutters unlock auto-
matically.
• Load the washing, close the drum and the lid
of your washing machine.
Warning! Before closing the lid of your
appliance, ensure that the drum is properly
closed :
• When the two shutters are closed,
• locking button A released.
Proportioning of detergents
Pour the amount of washing into the washing
and prewash compartments if you have
selected the “prewash” option. Pour fabric soft-
ener into the compartment if necessary.
Selection of desired programme
Turn the programme selector to the required
programme. The “Start/Pause” pushbutton
flashes green.
If you turn the programme selector to another
programme while a cycle is in progress, the ap-
1) Depending on model.
4
www.zanussi.com