Zenoah HC510DV - Manual (Page 13)

■ MOUNTING OF CUTTER BLADE
The flange bolt shall be securely fixed.
(Fixing torque: 266~434 in-lbs (30~50 N·m))
Insufficient fixing of the bolt may cause brake
away of the blade and is extremely dangerous.
1. Unscrew a flange bolt and remove flange
washer (A).
2. Mount a cutter blade on flange washer (B)
aligning its centre hole correctly with a projection
of the washer. Holding the blade with flange
washer (A), screw in the flange bolt.
(1) Cutter blade (2) Flange bolt
(3) Flange washer (A) (4) Flange washer (B)
3. Insert an attached bar (6mm diameter) to a hole
on pulley cover as shown in the left Fig. Slowly
turn the blade to find a hole on a belt pulley, and
apply locking of the pulley.
4. Securely tighten the flange bolt with an attached
eye wrench of 17mm diagonal size. (Specified
torque: 266~434 in-lbs (30~50 N·m))
(1) Pulley cover (2) Cutter blade
(3) Bar (4) Flange bolt
(5) Eye wrench (6) Tighten
These attached tools must be used also to remove
the cutter blade.
■ FITTING DUST HOSE AND DUST BAG
1. Connect an attached dust hose on an exhaust
outlet behind a fan cover of the machine.
Tighten the hose with a metal band securely.
2. Insert the end of the dust hose to the inlet of
dust bag and securely fix with a cord on the bag.
(1) Dust hose (2) Metal band
(3) Dust bag (4) Tying Cord
IMPORTANT
WARNING
6. Set up
SE2
SE3
13 
SE4