Storage – Zenoah HC510DV User Manual
Page 31
10. Storage
When discharging fuel, be careful not to spill
fuel and completely wipe off if spilled. Also,
securely close a cap of storage tank.
• In case the machine is left for long time, inside of
the carburetor may be clogged and cause
engine failure (starting failure or poor output
power).
• During storage, make fuel tank cap loose. If it is
tighten too much, cap packing may deform by
temporal change.
1. Remove the dust hose and the dust bag from
the body.
2. Open the dust bag fastener and remove internal
dusts completely.
3. Remove debris and dirt on the machine body.
4. After discharging fuel from the fuel tank, start the
engine and run until it stops.
5. Remove the spark plug and drop 1~2 cc of 2
cycle engine oil into the plug hole, then pull the
starter rope for 2~3 times. After fitting the spark
plug as original, pull the starter rope and stop at
compression position.
6. Fully slack the tension of pulley drive belt.
7. Fully slack the tension of fan drive belt.
8. Dismount the cutter blade.
9. After applying appropriate cover on the machine,
store it in an adequate place such as storage
shelf, keeping moisture, dusts and children
away.
IMPORTANT
WARNING
31