Care and cleaning – Zanussi ZWF 14791 W User Manual

Page 23

Advertising
background image

23

Care and cleaning

When no more water comes out, unscrew the

pump cover and remove it. Always keep a

rag nearby to dry up spillage of water when

removing the cover.

Remove any objects from the pump impeller

by rotating it.

Put the cap back on the emergency emptying

hose and place the latter back in its seat.

Screw the pump

cover fully in.

Close the pump door.

IMPORTANT!
When the appliance is in use and depending

on the programme selected there can be hot

water in the pump.

Never remove the pump cover during a wash

cycle, always wait until the appliance has

finished the cycle, and is empty. When

replacing the cover, ensure it is securely

retightened so as to stop leaks and young

children being able to remove it.

Cleaning the water inlet filter
If your water is very hard or contains traces of

lime deposit, the water inlet filter may become

clogged. It is therefore a good idea to clean it

from time to time.

Turn off the water tap.

Unscrew the water

inlet hose. Clean the

filter using a hard

bristle brush. Tighten

up the inlet hose.

The dangers of freezing
If the machine is exposed to temperatures

below 0°C, certain precautions should be

taken:
• pull out the plug from the power socket;
• turn off the water tap.
• unscrew the inlet hose.
• place a bowl with a small edge close to the

pump to collect any spillage from the

emergency emptying hose.

Place the end of the inlet hose in a bowl

placed on the floor and let water drain out.

• screw the water inlet hose back on and

reposition the emergency emptying cap on

again into the filter cover.

• when you intend to start the machine up

again, make sure that the room temperature

is above 0°C.

Emergency emptying out
If the water is not discharged, proceed as

follows to empty out the machine:
• pull out the plug from the power socket;
• close the water tap;
• if necessary, wait until the water has cooled

down;

• open the pump door using the suitable tool;
• place a bowl with a small edge close to the

pump to collect any spillage. Remove the

emergency emptying cap from the filter

cover.
The water should drain by gravity into the

Smart 132972560.qxd 18/06/2007 14.30 Pagina 23

Advertising