Installation instruction – Zanussi ZWF 14791 W User Manual

Page 34

Advertising
background image

34

WARNING!

The machine should NOT be placed on deep

pile carpeting.
NOTE
Please ensure that when the appliance is

installed it is easily accessible for the engineer

in the event of a breakdown.
In the interest of the environment
Washing machines and dishwashers should

be connected to the FOUL drainage system,

the water will then be taken to a sewage

works for treatment before being discharged

safely into a river. It is essential that these

appliances are not connected to the surface

water drainage system as this water is

discharged directly into a river or stream and

may cause pollution.

If you require any further advice please

contact your local water authority.

SHOWER

BATH

SINK TOILET

BIDET

WASHING

MACHINE

DISHWASHER

RAINWATER

'RUN-OFF'

SURFACE WATER

DRAINS & SEWERS

UNTREATED

DISCHARGE

RIVER

FOUL DRAIN

FOUL SEWERS

SEWAGE

TREATMENT

WORKS

RIVER

TREATED

DISCHARGE

Electrical connection
Any electrical work required to install this

appliance should be carried out by a qualified

electrician or competent person.

WARNING!

This appliance must be earthed.

The manufacturer declines any liability

should this safety measure not be

observed.
Before switching on, make sure the electricity

supply voltage is the same as that indicated on

the appliance’s rating plate.
IMPORTANT!
Information on the electrical connection is

given on the rating plate on the inner edge

of the appliance door.
The appliance is supplied with a 13amp plug

fitted. In the event of having to change the fuse

in the plug supplied, a 13amp ASTA approved

(BS1363/A) fuse must be used.
Should the plug need to be replaced for any

reason, proceed as described below.
The wires in the mains lead are coloured in

accordance with the following code:
Green and Yellow ..............................- Earth

Blue ....................................................- Neutral

Brown..................................................- Live

The wire coloured

green and yellow must

be connected to the

terminal marked with

the letter «E» or by the

earth symbol

or

coloured green and

yellow.

GREEN &YELLOW

BROWN

CORD CLAMP

BLUE

13

A

E

N

L

Installation instruction

Smart 132972560.qxd 18/06/2007 14.30 Pagina 34

Advertising