Yamaha CDM-900 - Manual (Page 21)

21
English
RELAY PLAY
If you have two CDM-900s, you can connect them and enjoy any combination play of 220 discs.
Connections
First, set the 2nd/MAIN switch of the unit connected to an amplifier to MAIN and the 2nd/MAIN switch of the other unit to 2nd. After
completing the connections as shown below, connect the power cords of both units to the AC outlet.
To amplifier
Set to
“MAIN”.
Set to “2nd”.
Main unit
2nd unit
Remote control cable (sold separately)
Notes
• The 2nd/MAIN switch should be set before plugging into the AC outlet.
• If relay play is not needed and each unit is used separately, the 2nd/MAIN switch on the rear panel of each unit should be set to
the “MAIN” position.
Never plug in these units or other components until all connections are completed.
After completing the connections, press the STANDBY/ON buttons of both units to turn the power on. “ACTIVE” appears in the
display of the main unit, ”INACTIVE” appears in the display of the second unit. Relay play (switching between both units) takes effect
according to the selected play mode.
LINE OUT DIGITAL AUDIO OUT
OPTICAL
2nd MAIN
2nd CHANGER INPUT
CONTROL
RELAY PLAY
LINE OUT DIGITAL AUDIO OUT
OPTICAL
2nd MAIN
2nd CHANGER INPUT
CONTROL
RELAY PLAY
2nd MAIN
2nd CHANGER
INPUT
CONTROL
RELAY PLAY LINE OUT
2nd MAIN
2nd CHANGER
INPUT
CONTROL
RELAY PLAY LINE OUT
L
R
R L
1
1