Zoom GFX-3 - Manual (Page 13)

Changing the Sound of a Patch
ZOOM GFX-3 13
ZNR/[TOTAL] module
COMP/ISO (Compressor/Isolator) module
DRIVE module
EQ(Equalizer) module
MOD(Modulation) module
REV/DLY(Reverb/Delay) module
The effect type of the MOD and REV/DLY
modules is set with the [MOD] selector and
[REV/DLY] selector respectively.
4. Use the module keys to select the
module to edit.
The module keys serve for selecting an effect
module to work with. The assignment of keys to
effect modules is shown above.
The keys for modules that are ON in a given
patch are lit. When you press a key to select the
module, the light flashes. (If you select a module
that is currently off, the key flashes more
slowly.)
5. To switch the module between ON
and OFF, press the module key
once more.
6.
Select the parameter to edit with
the parameter keys.
The parameter keys serve for choosing a
parameter within the currently selected module.
Each push of the key brings up the next
parameter, and the setting value of that
parameter is shown on the display.
The parameters that are assigned to the
parameter keys for each module are printed on
the panel. When the EQ module is selected, the
parameter keys correspond to the following
parameters.
NOTE
When you use the selector to switch the
effect type, the parameter type also changes.
Select the effect type first, and then select the
parameter.
7.
Use the [VALUE] dial to change the
setting.
The [VALUE] dial controls the setting value of
the currently selected parameter. The current
setting value is shown on the display.
8. Repeat steps 3 - 7 to edit other
modules and parameters.
NOTE
To keep the patch, be sure to perform the
steps for storing it (
→ p. 14). Otherwise all
changes will be lost when you switch to
another patch.
[MOD] Selector [REV/DLY] Selector
EQ modul
PRESENCE
TREBLE
MIDDLE
BASS
Parameters
En-GFX3.book 13 ページ ２００４年１１月８日 月曜日 午後４時３０分