Zoom gfx-3 – Zoom GFX-3 User Manual
Page 22
REV/DLY (Reverb/Delay) module
ZOOM GFX-3
22
[Table 3]
Parameter 3
MIX
0 – 30
Adjusts the reverb sound volume level.
TYPE 4: MN-DLY (
M
M
M
MD
D
D
D
) (Mono delay)
This is a monaural delay with a duration of up to 1.5 seconds.
TYPE 5: PP-DLY (
P
P
P
PD
D
D
D
) (Ping-Pong Delay)
When two amplifiers are used, this serves as a ping-pong delay effect with a duration of up to 1.5 seconds. When one amplifier is used, the effect is
a mono delay.
TYPE 6: ECHO (
E
E
E
EC
C
C
C
)
This is a monaural echo simulating a tape echo.
TYPE 7: PP-ECHO (
P
P
P
PE
E
E
E
) (Ping Pong Echo)
When two amps are used, the delay sound moves back and forth between them. When one amp is used, the effect is the same as for monaural echo.
* Parameters for TYPE 4 - 7 are the same.
Parameter 1
TIME
Parameter 2
FB
1 – 99, 1.0 – 1.5, t1 – t9
0 – 10
Adjusts the delay time in 10-ms steps in the range of 10 - 990 ms (1 -
99), and in 100-ms steps above 1 s (1.0 - 1.5). By selecting t1 - t9, you
can specify a note referenced to BPM as set with parameter 4. (See
Table 3)
Adjusts number of repeat cycles (feedback) for delay sound.
Parameter 3
MIX
Parameter 4
DLYBPM
0 – 30
40 – 199
Adjusts delay sound level.
Adjusts the delay time in BPM (beats per minute). This setting is valid
only when parameter 1 is t1 - t9. Settings of 100 and above are shown
with a dot (.) between the two figures.
Value
t1
t2
t3
t4
t5
t6
t7
t8
t9
Corresponding
note
half note
dotted
quarter note
quarter note
dotted
eighth note
half triplet
note
eighth note
dotted
sixteenth note
quarter
triplet note
sixteenth
note
TYPE 8: REVERSE (
R
R
R
RE
E
E
E
)
Produces a sound like a tape played in reverse.
Parameter 1
TIME
Parameter 2
FB
5 – 99, 1.0 – 1.5, t1 – t9
0 – 10
Adjusts the delay time.
Adjusts number of repeat cycles (feedback) for delay sound.
Parameter 3
MIX
Parameter 4
DLYBPM
0 – 50
40 – 199
Adjusts the delay sound level.
Adjusts the delay time in BPM (beats per minute). This setting is valid
only when parameter 1 is t1 - t9. Settings of 100 and above are shown
with a dot (.) between the two figures.
TYPE 9: DLYHAL (
D
D
D
DH
H
H
H
) (Delay + Hall Reverb)
This is a combined delay and hall reverb effect.
TYPE 10: DLY+ROOM (
D
D
D
DR
R
R
R
) (Delay + Room Reverb)
This is a combined delay and room reverb effect.
TYPE 11: DLY + SPRING (
D
D
D
DS
S
S
S
) (Delay + Spring Reverb)
This is a combined delay and spring reverb effect.
* Parameters for TYPE 9 - 11 are the same.
Parameter 1
DLYTIM
Parameter 2
DLYFB
1 – 50
0 – 10
Adjusts the delay time in 10-ms steps in the range of 10 - 500 ms.
Adjusts the delay feedback amount.
Parameter 3
DLYMIX
Parameter 4
REVMIX
0 – 15
0 – 15
Adjusts the delay sound level.
Adjusts the reverb volume level.
En-GFX3.book 22 ページ ２００４年１１月８日 月曜日 午後４時３０分