Zoom GFX-3 - Manual (Page 14)

ZOOM GFX-3 14
Storing a Patch
This section shows how to store an edited patch in memory.
1. Press the [STORE] key.
The GFX-3 goes into store standby condition.
The display shows the current group name and
bank number, and the LED of the respective foot
switch lights up.
HINT
A patch can be stored either while playing it
or while it is being edited.
2.
Use the BANK [ Q ]/[ W ] keys and the
foot switches [1] - [3] to select the
bank and patch number in which to
store the patch.
NOTE
Patches cannot be stored in a preset group. If
a patch from a preset group was selected
when you press the [STORE] key, the patch
number 1 of user group bank "U0" will
automatically be preselected as store target.
3. Press the [STORE] key once more.
The patch is stored, and the display shows the
group and bank of the store target. Since the
edited contents are now stored, the "EDITED"
dot on the display disappears.
If you press the [GROUP/EXIT] key instead of
the [STORE] key, storing is canceled.
Resetting the GFX-3 to the
factory default condition
The patches in the user groups can be returned to
their original condition at any time, even if you
have changed them.
1.
Turn power to the GFX-3 on while
keeping the [STORE] key
depressed.
The indication “AL” is shown on the display.
2. Press the [STORE] key once more.
All patches are reset to the factory default
condition, and the unit automatically switches to
play mode.
By pressing the [GROUP/EXIT] key before
carrying out step 2, you can cancel the operation
and go directly to the normal condition.
En-GFX3.book 14 ページ ２００４年１１月８日 月曜日 午後４時３０分