Zanussi ZWO 3101 - Manual (Page 11)

Change a function
You can change only the delay and spin function before
they operate.
Press the related button to set the new value.
Set the delay start
1. Press the delay start button again and again until the
display shows the number hours.
2. Press the start button, the appliance starts the count-
down of the delay start. The symbol h flashes in the
display and the start button indicator is off.
When the countdown is completed, the programme
starts automatically and the start button indicator
comes on.
You can cancel or change the set of the delay start
also when the appliance starts the countdown.
Cancel the delay start
Press the delay start button again and again until the dis-
play shows 0.
The programme starts and the start button indicator
comes on.
Open the door
While a programme operates, the appliance door is
locked.
To open the appliance door:
1. Turn the programme knob to to deactivate the
appliance.
2. Wait for some minutes before to open the appliance
door.
3. Close the appliance door.
4. Set the programme again.
If the temperature and level of the water in the drum
are too high, you cannot open the door.
To open the appliance door:
• Do the steps 1 and 2 again.
• Wait for some minutes.
• Make sure that no water is in the drum.
At the end of the programme
• The appliance stops automatically.
• The display shows the End symbols.
• Turn the programme knob to to deactivate the ap-
pliance.
• Remove the laundry from the appliance. Make sure that
the drum is empty.
• Keep the door ajar, to prevent mildew and odours.
• Close the water tap.
The washing programme is completed, but there is water
in the drum:
– The Rinse Hold function or a programme that stops
with water in the drum is set.
– The door stays locked and the start button indicator
flashes.
– You must drain the water before to open the door.
To drain the water:
1. If necessary, decrease the spin speed.
2. Press the start button. The appliance drain the water
and spin.
3. When the programme is completed:
– The display shows the End symbols.
– You can open the door.
4. Turn the programme knob to to deactivate the
appliance.
Care and cleaning
Warning!
Disconnect the appliance from the mains supply before
you clean it.
External cleaning
Clean the appliance only with soap and warm water. Fully
dry all the surfaces.
Caution! Do not use alcohol, solvents or chemical
products.
Descaling
The water we use contains limescale. If it becomes neces-
sary, use a water softener to remove limescales.
Use a special product made for washing machines. Obey
the instructions that you find on the packaging of the
manufacturer.
11