Zanussi ZWO 3101 - Manual (Page 19)

The inlet hose
• Connect the hose to the appliance. Loose the ring
nut to set it in the correct position.
• Connect the water inlet
hose to the cold water
tap with 3/4 thread.
Caution! Make sure that there are no leaks from the
couplings.
Do not use an extension hose if the inlet hose is too
short. Contact the service centre for the replacement
of the inlet hose.
Water drainage
There are different procedures to connect the drain hose:
With the plastic hose guide
• On the edge of a sink.
Make sure that the plastic guide cannot move when
the appliance drains. Attach the guide to the water
tap or the wall.
• To a stand pipe with vent-hole.
Refer to the illustration. Directly into a drain pipe at a
height of not less than 60 cm and not more than 90
cm. The end of the drain hose must always be venti-
lated , i.e. the inner diameter of the drainpipe must
be larger than the external diameter of the drain
hose.
Without the plastic hose guide
19