Zanussi ZWO 3101 - Manual (Page 13)

2. Put a container be-
low the recess of the
drain pump to collect
the water that flows
out.
3. Unscrew the filter to
let the water flow out.
4. When the container is full of water, screw the filter
again and empty the container. Do steps 3 and 4
again and again until no more water flows out
from the drain pump.
1
2
5. Unscrew the filter
and remove it.
6. Remove fluff and ob-
jects from the pump.
7. Make sure that the
impeller of the pump
can turn. If this does
not occur, contact
the service centre.
1
2
8. Clean the filter under
the water tap and put
it back in the pump.
Caution! Make sure
that you tighten cor-
rectly the filter to prevent
leakages.
9. Close the drain pump door.
Clean the inlet valve filter
It could be necessary to clean the filter when:
• The appliance does not fill with water.
• The appliance fills with the water for a long time.
Warning! Disconnect the mains plug from the mains
socket.
To clean the filter:
• Close the water tap.
• Remove the inlet hose behind the appliance.
• Clean the filter in the valve with a stiff brush or a
towel.
• Install again the inlet hose. Make sure that the cou-
plings are tight to prevent leakages.
• Open the water tap.
Emergency drain
Because of a malfunction, the appliance cannot drain the
water.
If this occurs, do steps (1) through (5) of 'To clean the
drain pump'.
If necessary, clean the pump.
When you drain the water with the emergency drain proce-
dure, you must activate again the drain system:
1. Put 2 litres of water in the main wash compartment
of the detergent dispenser.
2. Start the programme to drain the water.
13