Zenith R49W36 - Manual (Page 15)

P A G E 1 5
206-03865
Turning the TV On
On-Screen Displays
This page describes your on-screen display and information banner options.
First, connect antenna cable and power cord correctly. At this moment, the TV switches to standby mode.
In standby mode to turn TV on, press the POWER, CH UP/DOWN, TV/VIDEO, COMP or number buttons on the
remote control or ON/OFF, CH UP/DOWN or ENTER on the TV.
Select the viewing source by using TV/VIDEO or COMP on the remote control.
This TV is programmed to remember which mode it was last set to, even if you turn the TV off.
Note: See page 18 if you have not auto programmed the TV to receive channels in your local broadcast
area.
When finished using the TV, press the POWER button on the remote control. The TV reverts to standby
mode.
1
2
3
If you will be away on vacation, disconnect the power plug from the wall power outlet.
10 Mute
TV 15
MONO
10:00 AM
TV15 PIP Display
This display
appears when PIP
is active.
Volume
Volume level is displayed
while adjusting the sound. Mute
Appears when
sound is muted.
Time
Appears when pressing the
enter button on remote control.
Main Channel Display
Displays current channel number.