ZyXEL Communications ZyXEL DMA 1000 - Manual (Page 92)

IES-1000 User’s Guide
12-2 IP Commands
For example, if you want the IES-1000 to have 172.21.100.1 as the IP address, 255.255.255.0 for the subnet mask
and 172.21.100.254 for the default gateway, you may use the following command sequence:
192.168.1.1> ip
192.168.1.1 ip> enable ether 172.21.100.1
192.168.1.1 ip> subnet delete ether.home
192.168.1.1 ip> subnet add ether.home ether 172.21.100.0 ff:ff:ff:00
192.168.1.1 ip> route delete default
192.168.1.1 ip> route add default 0.0.0.0 172.21.100.254 00:00:00:00
192.168.1.1 ip> config save
Figure 12-1 Setting IP Address and Default Gateway
The IES-1000 leaves the factory with a default IP address of 192.168.1.1 and a subnet mask of 255.255.255.0, or
FF.FF.FF.0 in hexadecimal notation, and the default gateway set at 192.168.1.254. Make sure that you configure
the IP parameters correctly before you connect an IES-1000 to the network, otherwise, you may interrupt services
already running.
12.2 General IP Commands
The following is a list of general IP commands that help with the management of the IP parameters.
12.2.1 Config Command
Syntax:
192.168.1.1 ip> config [save]
This command shows the IP configuration. The save option saves the configuration to the nonvolatile memory.
12.2.2 Version Command
Syntax:
192.168.1.1 ip> version
This command shows the IP version and MAC address of the network module.