ZyXEL Communications ZyXEL DMA 1000 - Manual (Page 95)

IES-1000 User’s Guide
IP Commands 12-5
12.2.11 Enable Command
Your telnet session disconnects when you change the Ethernet port’s IP address. Initiate a
telnet session to the new IP address in order to reconnect.
Syntax:
192.168.1.1 ip> enable [<i/f> [mtu <size>] [<IPaddr>]]
where
<i/f> = The name of an interface (“ether” for this device).
[mtu <size>] = Maximum Transmit Unit. The maximum packet size that this interface is to
send.
<IPaddr> = The IP address of the device’s interface.
This command sets the Ethernet port’s IP address and the largest packet size that this interface sends.