Assembling the printer – Xerox 4512N User Manual
Page 8
S e t t i n g U p t h e D o c u P r i n t 4 5 1 2 / 4 5 1 2 N
6 ❖ S e t t i n g U p G u i d e
Assembling the
Printer
Assembling the printer is easily accomplished in just a few steps:
•
Install the Toner Cartridge.
•
Install the Photoconductor / Drum.
•
Install the Cleaning Felt.
•
Load the paper tray(s) with paper.
•
Attach the Manual Feed Guide and the Tray Extension.
•
Connect the power cord.
Follow the instructions below to assemble the printer.
Caution
Do not expose the Photoconductor / Drum to direct sunlight or
artificial light for more than 15 minutes. Overexposure will
permanently damage the photosensitive imaging drum.
Complete the Toner Cartridge and Photoconductor / Drum
installation within 15 minutes of removing them from their
packaging.
1
Open the top cover by pulling up on the top
cover release lever and pivoting the cover
toward the front of the printer.
2
Remove the Toner Cartridge from its wrapper
and shake it several times to evenly distribute
the toner.