Xerox DocuColor 5000 - Manual (Page 99)

DocuColor 5000 Administrator Guide 3-41
3. Profiles
• The output print in the output area is curled upwards and was
measured with a curl average of 10 mm (refer to Evaluate your
print output for paper curl ).
• Using the 1-Sided Face Up row, as shown below, enter the
known values into the table.
• Average curl is 10 mm upward and average toner area
coverage is 5%. Therefore, select Upward and enter 5%
for the 10 mm column.
• Enter any higher number for the 6 mm (such as 6%) and
the 2 mm (such as 7%).
• The printer will induce a 10 mm curl in the downward direction
for the 5% toner area coverage sheets in your job.
TIP:
When creating/editing a Decurler Profile, you must enter a
percentage value for 3-6 cells of the Downward and/or Upward
tables.
NOTE: The default value for each cell of the table is 100%.
Continue to the Decurler Profile procedure on page 3-42.